Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Customer Interest for Fuel Gauge Sender: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 290

Page 22
background image

FIGURE 4B - Mounting Fuel Resevoir/Filter

6.

Install one 5/16" x 8" hose, PN 4203576 (with convolute sleeve PN 4279993), from the fuel pump outlet tube to the reservoir/filter inlet
nipple, and clamp with PN 6500651 at each end (Figure 4-B).

7.

Install the other 5/16" x 8" hose, PN 4203576 (with convolute sleeve PN 4279993), from the reservoir outlet nipple to the carburetor fuel
tube, and clamp with PN 6500651 at each end (Figure 4-B).

NOTE:

IF EQUIPPED WITH THERMOQUAD CARBURETOR, DO NOT INSTALL HOSE TO CARBURETOR TUBE SINCE
FUEL TUBE WILL BE CHANGED IN SECTION F.

8.

Tighten all hose clamps to 10 inch pounds.

FIGURE 10

9.

Type Authorized Modification Label, PN 4275086, as shown in Figure 10 and attach near VECI label.

10.

For all models except 1981-1984 equipped with Carter Thermoquad 4BBL carburetor or dual air conditioning units without electrically

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Customer Interest for Fuel Gauge Sender: > 181985A > Dec > 85 > Fuel System - Vapor Lock > Page 290

[PREV PAGE] [NEXT PAGE]