PB 350 V8-318 5.2L VIN T 2-BBL (1983)
Frame: All Technical Service Bulletins
Recall #210T - Frame Reinforcement Plate Replacement
No... 210T March, 1983
TO:
INVOLVED CHRYSLER CORPORATION DEALERS
SUBJECT:
FRAME REINFORCEMENT PLATE REPLACEMENT
MODELS:
1983 PLYMOUTH VOYAGER AND DODGE VAN AND WAGON TRUCKS
Metal reinforcement plates (2 per vehicle) attached to the underside of the frame on a limited number of the subject model vehicles may be fabricated
from high carbon steel. Because of the high carbon content the spot welds attaching the plates to the frame are brittle and may break loose in service.
Broken welds will result in detachment of the plate and possible frame damage.
To eliminate the possibilty of frame damage, the vehicle(s) identified on the attached listing must be corrected immediately by removing the existing
plates and installing the supplied new plates. Refer to the attached Service Procedure for complete plate replacement instruction.
Listed stock vehicles must be brought in and corrected immediately. Do not wait until new vehicle preparation to perform this service. If you have
already delivered a suspect vehicle, please contact and advise your customer to return it as soon as possible for corrective service.
REIMBURSEMENT Complete a separate WRO for each vehicle serviced and identify the claim as Recall #210T - Frame Reinforcement Plate
Replacement. Use the following Labor Operation Number and Time Allowance:
LABOR OPERATION
TIME
NUMBER
ALLOWANCE
Replace Frame Reinforcement Plates
Both Sides
13210282
1.4 Hours
IMPORTANT:
DO NOT PROCESS THE CLAIM IN THE NORMAL MANNER. SUBMIT THE CLAIM FOR EACH VEHICLE SERVICED TO
YOUR ZONE OFFICE TECHNICAL ADVISOR FOR REIMBURSEMENT.
SERVICE PROCEDURE - FRAME REINFORCEMENT PLATE REPLACEMENT
IMPORTANT:
Do not attempt to simply add welds to the existing plate to correct the condition. The installed plates are fabricated from steel that
cannot be properly welded. The plates must be replaced.
1.
Raise vehicle on hoist.