Plymouth Workshop Manuals
Prowler V6-3.5L VIN G (1999)
Brakes and Traction Control > Brake Warning Indicator > Component Information > Technical Service Bulletins > Recalls for Brake Warning Indicator: > 844 > Sep > 99 > Recall - Brake Warning Lamp Wiring Jumper > Page 3525
Disconnect the two-way wiring connector on the brake combination valve (Figure 1).
Using a small screwdriver, slide the white lock wedge to the unlock position in the two-way connector (Figure 2).
Remove and discard the green rubber plug from the two-way connector (if present).
Insert the wiring jumper female terminal into the open cavity at the rear of the two-way connector.
The terminal can only be installed one way. The terminal will click when it is fully seated in the two-way connector.
Slide the white lock wedge back to its locked position into the two-way connector (Figure 2).
Pull back gently on both connector wires to verify both wire terminals are properly locked into position in the two-way connector.
Install the two-way connector onto the combination valve brake warning switch.
|[PREV PAGE] [NEXT PAGE]|