Prowler V6-3.5L VIN G (1999)
Park Brake Cable Routing
10. Route the park brake cable under the carpeting per illustration to the park brake cable retaining bracket on floor pan.
11. Install park brake cable into retaining bracket
Be sure tabs on park brake cable retainer, have expanded out to hold park brake cable in retaining bracket.
12. Install routing clip on park brake cable and on stud in floor pan. Install and securely tighten nut attaching routing clip to floor pan stud.
13. Install rear park brake cables into equalizer on park brake lever cable.
14. Unfold carpeting and correctly position on body panel.
15. Place the seat and seat back in the original position.
16. Firmly grasp park brake lever locking pin (3/16 inch drill bit) and quickly remove it from park brake lever mechanism. This will allow the park
brake lever mechanism to correctly adjust park brake cables.
17. Cycle park brake lever ounce to position park brake cables. Then return park brake lever to its released position. Check rear wheels of vehicle,
they should rotate freely without dragging.
18. Lower vehicle.
19. Raise park brake lever to its fully engaged position. This is necessary to allow installation of the center console.
20. Install center console.
21. Lower park brake lever to the released position.
22. Install the 4 screws, mounting console, storage tray and lid.
23. Install screw mounting front of center console to console bracket.
24. Connect shift bezel wiring harness to vehicle wiring harness.
25. Install shift bezel on center console. Shift bezel is installed by firmly pressing it down on center console until the 4 retaining clips are holding it to
the center console.
26. Install shift knob on shifter. Install and securely tighten set screw holding shift knob to shifter. Access to set screw is from the front side of the shift
knob.
