Plymouth Workshop Manuals
Prowler V6-3.5L VIN G (1999)
Maintenance > Tune-up and Engine Performance Checks > Fuel Filter > Fuel Pressure Release > System Information > Service Precautions > Page 666
Fuel Pressure Release: Service and Repair
1. Remove Fuel Pump relay from Power Distribution Center (PDC). For location of relay, refer to label on underside of PDC cover.
CAUTION: Steps 1, 2, 3 and 4 must be performed to relieve high pressure fuel from within fuel rail. Do not attempt to use following steps to
5. Unplug connector from any injector.
CAUTION: Powering an injector for more than a few seconds will permanently damage the injector.
9. Momentarily touch other end of jumper wire to negative terminal of battery for no more than a few seconds.
10. Place a rag or towel below fuel line quick-connect fitting at fuel rail.
be used to erase a DTC. Refer to Emission Control System. See On-Board Diagnostics.
|[PREV PAGE] [NEXT PAGE]|