Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


Prowler V6-3.5L VIN G (1999)

Powertrain Management > Computers and Control Systems > Data Link Connector > Component Information > Diagrams > Diagram Information and Instructions > Page 2132

Page 12
background image

Terminal Removal

Terminal Removal Using Special Tool

4. Position the connector locking finger away from the terminal using the proper pick from Special Tool Kit 6680. Pull on the wire to remove the

terminal from the connector.

5. Cut the wire 6 inches from the back of the connector.
6. Remove 1 inch of insulation from the wire on the harness side.
7. Select a wire from the terminal repair assembly that best matches the color of the wire being repaired.
8. Cut the repair wire to the proper length and remove 1 inch of insulation.
9. Place a piece of heat-shrink tubing over one side of the wire. Be sure the tubing will be long enough to cover and seal the entire repair area.

Wire Repair

Powertrain Management > Computers and Control Systems > Data Link Connector > Component Information > Diagrams > Diagram Information and Instructions > Page 2132

[PREV PAGE] [NEXT PAGE]