Plymouth Workshop Manuals
Prowler V6-3.5L VIN G (1999)
Powertrain Management > Computers and Control Systems > Idle Speed/Throttle Actuator - Electronic > Component Information > Specifications > Page 2192
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Throttle Position Sensor
The idle air control motor is located at the rear of the intake manifold plenum on the throttle body.
1. Remove electrical connector from idle air control motor.
1. The new idle air control motor has a new O-ring installed on it. If pintle measures more than 1 inch (25 mm) it must be retracted. Use the DRB
IAC Motor Open/Close Test to retract the pintle (battery must be connected.)
2. Carefully place idle air control motor into housing.
|[PREV PAGE] [NEXT PAGE]|