Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


Prowler V6-3.5L VIN G (1999)

Powertrain Management > Computers and Control Systems > Oxygen Sensor > Component Information > Service and Repair > Upstream Heated Oxygen Sensor Replacement > Page 2263

Page 2
background image

Heated Oxygen Sensor Removal/Installation - Left Side

2. Use a socket such as Snap-On YA8875 or Special tool C4907A to remove oxygen sensor.

INSTALLATION

1. After removing the sensor, the exhaust manifold threads must be cleaned with an 18 mm X 1.5 + 6E tap. If reusing the original sensor, coat the

sensor threads with an anti-seize compound such as Loctite 771-64 or equivalent. New sensors have compound on the threads and do not require
an additional coating. Tighten the sensor to 28 Nm (20 ft. lbs.) torque.

2. Connect the heated oxygen sensor electrical connector.

Passenger Side

Upstream Heated Oxygen Sensor - Right Side

Powertrain Management > Computers and Control Systems > Oxygen Sensor > Component Information > Service and Repair > Upstream Heated Oxygen Sensor Replacement > Page 2263

[PREV PAGE] [NEXT PAGE]