Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


Prowler V6-3.5L VIN G (1999)

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Powertrain Control Module <--> [Engine Control Module] > Component Information > Diagrams > Diagram Information and Instructions > Page 2345

Page 10
background image

Connector Replacement

1. Disconnect the battery.
2. Disconnect the connector (that is to be repaired) from its mating half/component.

Connector Locking Wedge

3. Remove the connector locking wedge, if required.

Terminal Removal

Terminal Removal Using Special Tool

4. Position the connector locking finger away from the terminal using the proper pick from Special Tool Kit 6680. Pull on the wire to remove the

terminal from the connector.

5. Reset the terminal locking tang, if it has one.
6. Insert the removed wire in the same cavity on the repair connector.
7. Repeat steps 4 through 6 for each wire in the connector, being sure that all wires are inserted into the proper cavities.
8. Insert the connector locking wedge into the repaired connector, if required.
9. Connect the connector to its mating half/component.

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Powertrain Control Module <--> [Engine Control Module] > Component Information > Diagrams > Diagram Information and Instructions > Page 2345

[PREV PAGE] [NEXT PAGE]