Plymouth Workshop Manuals
Prowler V6-3.5L VIN G (1999)
Powertrain Management > Fuel Delivery and Air Induction > Throttle Body > Component Information > Technical Service Bulletins > Customer Interest for Throttle Body: > 14-02-99 > Jun > 99 > Engine - Hissing Noise When Idling > Page 2829
Disconnect electrical connectors.
Disconnect top vacuum hose.
Remove 3 throttle body bolts.
Remove throttle body support bracket bolt (LH only).
Remove throttle body assembly.
Hold throttle lever in the wide open position. Remove throttle cable and speed control cable from throttle arm.
Clean mating surfaces.
Hold throttle lever on new throttle body in wide open position. Install throttle cable and speed control cable.
Install throttle body. Tighten bolts to 12 Nm (105 in. lbs.).
Tighten throttle body support bracket bolt to 27 Nm (240 in. lbs.) (LH only).
Install purge vacuum hose.
Install throttle cable bracket.
Install air plenum.
Install cowl plenum (LH only).
Install cowl screen (LH only).
Install wiper arms (LH only).
Connect negative battery cable to remote terminal.
|[PREV PAGE] [NEXT PAGE]|