Plymouth Workshop Manuals
Prowler V6-3.5L VIN G (1999)
Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Camshaft Position Sensor > Component Information > Specifications > Page 1927
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
The camshaft position sensor is installed in the timing belt housing cover above the left camshaft sprocket.
1. Disconnect the negative battery cable.
If the original sensor is being reinstalled, clean off the old spacer on the sensor face. Attach a NEW SPACER to the face of the sensor before
1. Install sensor in the timing belt housing and push sensor down until contact is made with the camshaft sprocket. While holding the sensor in this
position, install and tighten the retaining bolt to 12 Nm (105 in. lbs.) torque.
2. Attach electrical connector to sensor.
|[PREV PAGE] [NEXT PAGE]|