Plymouth Workshop Manuals
Prowler V6-3.5L VIN G (1999)
Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Knock Sensor > Component Information > Specifications > Page 436
Knock Sensor: Service and Repair
The engine uses one knock sensor. The sensor is bolted into the cylinder block, directly below the intake manifold.
1. Remove intake manifold plenum and intake manifold.
1. Install knock sensor. Tighten bolt to 10 Nm (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance, possibly causing
improper spark control.
2. Attach electrical connector to knock sensor.
|[PREV PAGE] [NEXT PAGE]|