Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


Prowler V6-3.5L VIN G (1999)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Camshaft Position Sensor > Component Information > Specifications > Page 525

Page 1
background image

Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor

The camshaft position sensor is installed in the timing belt housing cover above the left camshaft sprocket.

REMOVAL

1. Disconnect the negative battery cable.
2. Remove the upper intake plenum.
3. Disconnect electrical connector from sensor.
4. Remove camshaft position sensor screw.
5. Pull sensor up out of the timing belt housing cover.

INSTALLATION

Paper Spacer

If the original sensor is being reinstalled, clean off the old spacer on the sensor face. Attach a NEW SPACER to the face of the sensor before
installation. If installing a new sensor, confirm that the paper spacer is attached to the face.

1. Install sensor in the timing belt housing and push sensor down until contact is made with the camshaft sprocket. While holding the sensor in this

position, install and tighten the retaining bolt to 12 Nm (105 in. lbs.) torque.

2. Attach electrical connector to sensor.
3. Install the upper intake plenum.
4. Connect the negative battery cable.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Camshaft Position Sensor > Component Information > Specifications > Page 525

[PREV PAGE] [NEXT PAGE]