Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


Prowler V6-3.5L VIN G (1999)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Ignition Switch Lock Cylinder > Component Information > Service and Repair > Ignition Lock Cylinder Replacement > Page 540

Page 2
background image

Socket In Lock Cylinder Housing

2. The shaft at the end of the lock cylinder aligns with the socket in the end of the housing. To align the socket with the lock cylinder, ensure the

socket is in the RUN position.

Lock Cylinder Installtion

3. Align the lock cylinder with the grooves in the housing. Slide the lock cylinder into the housing until the tab sticks through the opening in the

housing.

4. Turn key to OFF position. Remove key.
5. If the vehicle has column shift and a new lock cylinder was used, install and adjust a new interlock cassette. Refer to Ignition Interlock. If the

vehicle has a floor shift, adjust the interlock cable when the lock cylinder is replaced. Refer to the Floor Shift Interlock Adjustment procedure.

6. Install upper and lower cover on steering column.
7. Install tilt lever.
8. Connect negative cable to battery.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Ignition Switch > Ignition Switch Lock Cylinder > Component Information > Service and Repair > Ignition Lock Cylinder Replacement > Page 540

[PREV PAGE] [NEXT PAGE]