Prowler V6-3.5L VIN G (1999)
Starter Motor: Service and Repair
CAUTION: The generator output terminal must be connected to the battery positive terminal of the starter solenoid. For the charging and cranking
systems to operate properly.
REMOVAL
1. Disconnect battery negative cable.
2. Raise vehicle.
3. For easier servicing, loosen the V-ban clamp from the exhaust manifold for starter removal clearance.
Starter Removal
4. Remove three bolts attaching starter to transmission housing and remove starter from vehicle.
Wire Terminal Connection
5. Remove battery positive cable nut from starter and remove cable.
6. Disconnect push on solenoid connector.
7. Remove the starter from vehicle.
INSTALLATION
-
For installation, reverse the above procedures. Clean corrosion/dirt from wire terminals before installing wiring to the solenoid.