Prowler V6-3.5L VIN G (1999)
Stabilizer Link: Testing and Inspection
Rear
Inspect the stabilizer bar attaching links for any of the conditions which are listed below. If any of these conditions are found when inspecting the
stabilizer bar links, the link will require replacement. Do not attempt to repair a stabilizer bar attaching link.
-
Inspect the attaching links for any bending of the center section of the link.
-
Inspect the attaching link bushings for end play or excessive looseness. If any of these conditions are found the attaching link will need to be
replaced.
-
Check the attaching link mounting points at the stabilizer bar and lower control arm to be sure the mounting nuts are tight. If required tighten the
nuts to the specified torque.