Sundance L4-135 2.2L SOHC (1987)
![background image](/plymouth/sundance/l4-135_2.2l_sohc/Page-99001.png)
Turn Signal Switch: Service and Repair
Lock plate removal. Models with tilt column exc. Horizon, Omni, Charger & Turismo
Turn signal switch replacement. Exc. Horizon, Omni, Charger & Turismo
EXC. HORIZON, OMNI, CHARGER & TURISMO
1. Disconnect battery ground cable.
2. Remove horn button and switch and steering wheel nut, then the steering wheel using a suitable puller.
3. Remove instrument panel lower bezel and steering column cover.
4. On models with tilt steering column, remove transmission gearshift indicator, then two nuts attaching steering column to lower panel. Remove four
attaching bolts, then the bracket from column.
5. On models less tilt column, position gearshift lever into its full clockwise position. On models with tilt column, place gearshift lever to its midway
position.
6. On models with tilt column, carefully remove plastic cover from lock plate, then depress lock plate with tool No. C-4156 and remove snap ring.
Remove lock plate, canceling cam and upper bearing spring from steering shaft.
7. Remove turn signal lever attaching screws and lever. On models with speed control allow lever to hang from column.
8. Remove turn signal switch and upper bearing attaching screws. Carefully remove turn signal switch, while guiding wire up through column
opening.
9. Reverse procedure to install.