Turismo L4-97 1.6L SOHC (1984)
If rattle stops check for wear marks on
present.
underside of hood at rear fender stabilizer.
4.
Close the hood. Reach through slots in Place foam insulation under leg of cover hood with pencil and touch top of where it
contacts plenum.
plastic wiper motor cover. Omni, Horizon, Turismo, Charger, Rampage, and Scamp.
5.
Check that the brake booster hose is not Route hose forward of the flow control touching the fire wall (2.2 engine only). valve on
manifold.
6.
Check to see if fuel lines are vibrating Pull lines forward and place 2-3 layers of on sheetmetal. tape around fuel lines.
Isolate with foam
if required.
7.
Check to see if the brake line is Bend line away from sheetmetal. vibrating against sheetmetal.
8.
Check to see if the head lamp bezels are Tighten screws. loose and vibrating on fender.
9.
Check to see if any of the fender bolts Tighten. are loose.
Problem
Repair
10.
Tap on washer reservoir and listen for
Remove reservoir and rotate pump about
metal-to-metal noise. Omni, Horizon,
20~ counterclockwise. Check reservoir
Turismo, Charger, Rampage, and Scamp.
for leaks around seal. Reinstall reservoir.
11.
Check to see if the wiring harness
Route away from air cleaner.
touches the air cleaner (2.2 engine).
12.
Check to see if lower hose clamp on
Rotate clamp to obtain clearance.
the water valve is touching the air cleaner.
(Left side on 2.2 engines with A/C.)
13.
Check to see if vacuum actuator on the
Place foam on stud.
water valve is touching the brake booster
housing stud (lower left - A/C cars only).
14.
If vehicle is equipped with a manual
Adjust cable away from air cleaner and
transaxle and no speed control, check
re-tie strap down to heater hose.
to see if metal speedo cable connector
touches air cleaner (2.2 engine only).
15.
Check H-valve and the evaporator term-
Grasp suction line close to H-valve and
ination plate to which it is mounted for
move it in direction necessary to provide
contact with sheetmetal.
clearance between valve and sheetmetal.
Then place foam around valve to form seal
between valve and sheetmetal, if required.
Instrument Panel Top Cover Area (23-19-60-00)
Problem
Repair
1.
Cover touching windshield at outboard
Remove cover, loosen panel mount
edges. Use a piece of paper to check
screws, press down on panel and
for clearance. Omni, Horizon, Turismo,
retighten. Reinstall cover and slide
Charger, Rampage, and Scamp.
laterally to minimize contact. If still
touching, install felt "dot" on cover at
point of contact. Refer to Item #4 before installing cover.
2.
Tap lightly on top cover at center and
Place foam on the top of the panel at
listen for metal-to-metal sound. If
attaching points, forward and touching
present, check for loose screws. If not,
the fence line. The center locations are
remove top cover and check foam place-
the critical areas, foam must be on the
ment. NOTE: THE FOAM IS LOCATED
top of the bracket and forward. (Foam
ON THE METAL FLANGE THAT THE IN-
should be slightly visible after cover
STRUMENT PANEL MOUNTS TO. IF THIS
is replaced.) Refer to next step before