Voyager V6-201 3.3L (1991)
Repair Procedure
This repair involves replacement of the actuator piston assemblies with revised pistons.
WARNING:
FAILURE TO DE-PRESSURIZE THE HYDRAULIC ACCUMULATOR, BEFORE DOING THIS REPAIR, MAY RESULT IN PERSONAL INJURY
AND/OR DAMAGE TO PAINTED SURFACES. WEAR SAFETY GOGGLES WHEN DISCONNECTING FLUID LINES. KEEP WORK AREA
CLEAN. AVOID CONTAMINATION OF SYSTEM COMPONENTS WITH DIRT OR FOREIGN MATERIAL. USE CLEAN BRAKE FLUID
SUCH AS MOPAR OR EQUIVALENT, CONFORMING TO DOT 3 REQUIREMENTS.
1.
With the ignition key in the OFF position, discharge the ABS accumulator by pumping the brake pedal 40 times.
2.
Remove the hydraulic unit from the vehicle as outlined in the appropriate service manual, and place on a clean, dry work bench.