Voyager V6-201 3.3L (1991)
Oxygen Sensor: Service and Repair
1.
Using tool No. C-4907, or equivalent, remove the oxygen sensor.
2.
After removal, clean the threads in the exhaust using an 18 mm X 1.5 X 6E tap.
3.
If reinstalling the same sensor, apply a suitable anti-seize compound (Loctite Pt. No. 771-64 or equivalent) to the threads of the sensor. New
sensors are packaged with an anti-seize compound already applied to the threads and no further application is needed.
4.
When installing the sensor, torque to 20 lbs. ft. (27 N-m).