Voyager V6-229 3.8L (1996)
wiper park switch input status does not change as the wipers are moving, the park switch circuit is faulty.
2.
Check for continuity between pin # 41 of the B58 BCM connector and pin # 4 of the wiper module B31 connector, refer to the illustration.
3.
Check for continuity between pin # 7 of the B31 wiper module connector and ground.
4.
If a problem is found in steps 1 through 3, perform the Repair Procedure for Symptom 3.
PARTS REQUIRED:
AR*
4685267
Switch, Multi-function (With Build Date Code After 2565).
AR*
4707730
Power Distribution Center (PDC), With Antilock Brake System (ABS) and With 41TE Transaxle
AR*
4868131
Power Distribution Center (PDC), With Antilock Brake System (ABS) and Without 41TE Transaxle
AR*
4673013
Motor, Wiper
*AR = As Required
REPAIR PROCEDURE:
This bulletin involves installing a multi-function switch with a build date code after 2565 and/or ground wire correction and/or a PDC and/or a wiper
motor.