Voyager V6-3.0L VIN 3 (1998)
Rocker Arm Assembly: Service and Repair
Rocker Arm Replacement
INSTALL ROCKER ARM SHAFT ASSEMBLY
Rocker Arm Shaft Direction
1. Apply Mopar (R) Silicone Rubber Adhesive Sealant at bearing cap ends as shown in image.
2. Install the rocker arm shaft assembly making sure that the arrow mark on the bearing cap and the arrow mark on the cylinder head are in the same
direction.
NOTE: The direction of arrow marks on the front and rear assemblies are opposite to each other.
3. Tighten bearing cap bolts in the following order to 10 Nm (85 inch lbs.). First #3, then #2, #1 and #4.
4. Repeat step 3 increasing the torque to 20 Nm (180 inch lbs.).
Distributor Drive
5. Install distributor drive adaptor assembly.