Voyager V6-3.3L VIN G Flex Fuel (2000)
positioned squarely against the face of the caliper piston.
Installing Outboard Brake Shoe
5. Slide the new outboard brake shoe onto the brake caliper.
6. Lubricate both steering knuckle abutments with a liberal amount of Mopar (R) Multipurpose Lubricant, or equivalent.
CAUTION: Use care when installing the caliper assembly onto the steering knuckle, so the seals on the caliper guide pin bushings do not get
damaged by the steering knuckle bosses.
7. Carefully position the brake caliper and brake shoes over brake rotor by hooking lower or upper end of caliper over the machined abutment on
steering knuckle. Next, rotate the caliper into position at the top of the steering knuckle. Make sure that caliper guide pin bolts, bushings and
sleeves are clear of the steering knuckle bosses.
8. Install the caliper guide pin bolts and tighten to a torque of 22 Nm (195 inch lbs.).
Extreme caution should be taken not to cross thread the caliper guide pin bolts.
9. Install the wheel and tire assembly.
10. Using a torque wrench, tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification, then repeat the
tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
11. Repeat the above procedure on other side of the vehicle.
12. Lower vehicle.
13. Check and adjust brake fluid level as necessary.
14. Before moving the vehicle, pump the brake pedal several times to insure the vehicle has a firm brake pedal.
Rear
NOTE: Before proceeding with this procedure, review the Service Warnings and Cautions found in Service Precautions.
REMOVAL
1. Raise vehicle on jackstands or centered on a hoist. See Hoisting in Maintenance.
2. Remove rear wheel and tire assemblies from vehicle.
Removing Caliper Guide Pin Bolts
3. Remove the caliper to adapter guide pin bolts.