Voyager V6-3.3L VIN G Flex Fuel (2000)
Transmission Control Module: Service and Repair
The Transmission Control Module is located on the right fender inner panel, in the engine compartment. It is held in place by four mounting screws.
NOTE: If the Transmission Control Module has been replaced, the following procedures must be performed:
-
Quick Learn Procedure: This procedure will allow the transmission control module to learn the characteristics of the vehicle.
-
Electronic Pinion Factor Procedure: This procedure will reprogram the TCM to compensate for different tire sizes and final drive ratios.
REMOVAL
Fig. 57
(1) Loosen 60 way retaining screw, located in the center of the 60 way connector (Fig. 57). Then disconnect the 60 way connector on Transmission
Control Module.
Fig. 58