6000 V6-173 2.8L (1988)
I).
Allow engine to run for at least 5 minutes.
Install Tech 1 Scanner tool, CAMS or equivalent. Program into Scan-Tool 1989 model year.
With engine stabilized and in closed loop, the IAC motor position values should be between 9-20 counts for a desired RPM of 700 (Auto. Trans. and 850
Manual Trans.). If not, the adjustments may be tailored as follows, by adjusting the minimum air rate screw.
-
More throttle valve opening = lower IAC valve counts
-
Less throttle valve openings = higher IAC valve counts
IMPORTANT:
Throttle angle must be equal to zero.
After a MEM-CAL replacement, the 1987-88 2.8L Speed Density Engine Driveability and Emissions Manual, ST399-87/88 SDM, must be used for
Driveability and Emissions Diagnostics. To secure additional publications use order forms available to all dealers through Helm, Inc., or dial (313)
865-5000 and ask for Customer Service.
Use applicable labor operations and times.
(Labor Operation Number:
J5670 for MAF/MAT replacement).
(Labor Operation Number:
T1492 for MEM-CAL change, as follows: 6000 = 1.1 Hour Grand Prix = 1.0 Hour
Add 0.1 hour to the above times to adjust minimum idle.