Aztek V6-3.4L VIN E (2001)
1. Install the EBCM (1) to the BPMV (5).
^
Tighten the top four mounting screws (2) to 2.9 Nm (26 inch lbs.).
^
Tighten screws in an X pattern.
^
Tighten the bottom two mounting screws (2) to 2.9 Nm (26 inch lbs.).
2. Connect the pump motor connector (3) to the bottom of the EBCM.
3. Connect the EBCM harness connector. Push in lock tab (1).
4. Install the air cleaner assembly.
5. Turn the ignition switch to the ON position, engine off.
6. Perform the ABS diagnostic system check. Refer to Diagnostic System Check-ABS.