Aztek AWD V6-3.4L VIN E (2004)
1. Drill 8 mm (5/16 in.) plug weld holes in the service part as necessary in locations noted from the original panel.
2. Prepare all attachment surfaces as necessary.
3. Apply weld-thru primer to all baremetal surfaces.
4. Position the Rear End Panel.
5. Plug weld accordingly.
IMPORTANT: Prior to refinishing, refer to publication GM4901M-D-01 GM Approved Refinish Materials for recommended products. Do not
combine paint systems. Refer to paint manufacturer's recommendations.
6. Clean and prepare all welded surfaces.
7. Apply the following as necessary:
-
Anti-corrosion materials
-
Sound deadeners
-
Sealers