Aztek AWD V6-3.4L VIN E (2004)
6. For the VERSATRAK AWD emblem/nameplate install to the following dimensions:
*
Dimension (a) is 58.750 mm (2.313 in) from the left edge of the lift gate to the side of the emblem/nameplate.
*
Dimension (b) is 19.05 mm (0.750 in) from the top of the lift gate lower molding to the bottom of the emblem/nameplate.
7. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.
8. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing on the emblem/nameplate.
9. Remove the protective liner from the back of the emblem/nameplate.
10. Position the emblem/nameplate to the location marks and press the emblem/nameplate to the mounting surface.
11. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
12. Remove the protective tape from the mounting surface.