Aztek AWD V6-3.4L VIN E (2004)
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the nut to the grille emblem.
Tighten the nut to 2 N.m (18 lb in).
3. Install the grille to the front fascia. Refer to Fascia Grille Replacement (Aztek) (See: Grille/Service and Repair/Fascia Grille Replacement (Aztek)
)Fascia Grille Replacement (Rendezvous) (See: Grille/Service and Repair/Fascia Grille Replacement (Rendezvous)) in Bumpers.
Emblem Replacement - Hood
Emblem Replacement - Hood
Tools Required
J 25070 Heat Gun
Removal Procedure
1. Apply masking tape to the area around the hood emblem to protect the finish.
2. Open the hood.
3. Remove the nuts from the back of the hood emblem.
4. To remove the emblem from the hood, heat the emblem using the J 25070 152 mm (6.0 in) from the surface.
5. Apply heat in a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
6. Use a plastic, flat bladed tool to lift or remove the emblem from the hood.