Aztek AWD V6-3.4L VIN E (2004)
1. Remove the key from the ignition.
2. Connect the harness connector from the sensor (1).
3. Install the orange CPA (2) from the yellow sensor harness connector (3).
4. Install the SIR Fuse.
5. Install the console accessory wiring junction block access hole cover.
6. Staying well away from all inflator modules and pretensioners, turn ON the ignition.
6.1.
The AIR BAG indicator will flash 7 times.
6.2.
The AIR BAG Indicator will then turn OFF.
7. Perform Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 2
SIR DISABLING AND ENABLING ZONE 2
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Service Precautions.
