Aztek AWD V6-3.4L VIN E (2004)
5. Place the front bucket seat to the most forward position.
6. Install the front screw to the front seat cushion trim panel.
Tighten
Tighten the front seat cushion trim panel front screw to 43 N.m (32 lb ft).
7. Place the front bucket seat to the most rearward position.
8. Install the rear screw to the front seat cushion trim panel.
Tighten
Tighten the front seat cushion trim panel rear screw to 43 N.m (32 lb ft).
IMPORTANT: The lumbar control knob splines must be properly aligned for proper fit.
9. Install the front seat lumbar control knob, pressing into place until fully seated.