Aztek AWD V6-3.4L VIN E (2004)
1. Remove the front seat lumbar control knob by pulling off.
2. Remove the front seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front (See: Seat Back/Service and
Repair/Removal and Replacement/Seat Back Recliner Handle Replacement - Front) .
3. Place the front bucket seat to the most rearward position.
4. Remove the screw from the rear of the front seat cushion trim panel.
5. Place the front bucket seat to the most forward position.
6. Remove the screw from the front of the front seat cushion trim panel.
7. Remove the screw from the center of the front seat cushion trim panel.
8. Remove the front seat cushion trim panel from the front seat.
9. Remove the power seat switch from the front seat cushion trim panel, if equipped.
10. Remove the front seat cushion trim panel from the vehicle.
Installation Procedure
1. Install the power seat switch to the front seat cushion trim panel , if equipped.