Aztek AWD V6-3.4L VIN E (2004)
4. Install the BPMV bracket to the strut tower.
5. Install the 3 nuts (2) that attach the BPMV mounting bracket to the strut tower.
^
Tighten the nuts to 10 Nm (89 inch lbs.).
^
Reposition any lines or hoses that were moved out of place.
6. Caution: Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake,
wheel lockup will occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by
doing an Antilock stop.
Important: If a new BPMV is being installed, remove the shipping plugs from the valve openings during the next few steps when ready.
Install the master cylinder brake pipes into the BPMV.
Tighten the fittings to 24 Nm (18 ft. lbs.).
7. Install the 4 wheel brake pipes on the BPMV.
Tighten the fittings to 25 Nm (18 ft. lbs.).
8. Connect the EBCM to BPMV connector.
