Aztek AWD V6-3.4L VIN E (2004)
3. Install the lubricated boot (1) onto the brake caliper piston (2).
4. Lubricate the brake caliper piston (2) with clean brake fluid.
5. Install the brake caliper piston and the brake caliper piston boot into the bore of the caliper. Push the brake caliper piston to the bottom of the bore.
6. Seat the caliper boot in the caliper housing counterbore using the J36349.
7. Install the caliper.
Rear
Brake Caliper Overhaul - Rear
Removal Procedure
1. Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
Remove the rear brake caliper from the vehicle.
2. Caution: Do not place fingers in front of the caliper piston(s) in an attempt to catch or protect it when applying compressed air. The
piston(s) can fly out with force and could result in serious bodily injury.
Notice: Use clean cloths to pad interior of caliper housing during piston removal. Use just enough air to ease the pistons out of the bores. If the
pistons are blown out, even with the padding provided, it may be damaged.
Remove the brake caliper piston from the caliper bore by directing low pressure compressed air into the caliper bore through the fluid inlet hole.