Aztek AWD V6-3.4L VIN E (2004)
2. Clean all dirt and foreign material from the brake hoses and the fittings.
3. Remove the brake pipes (1) from the brake hose (2).
4. Remove the retainers from the brake hose at the brackets.
5. Remove the hose from the brackets.
6. Remove the hose.
Installation Procedure
1. Important: Ensure that there are no kinks in the brake hose.
Align the hose fitting with the notch in the brackets.
2. Install the brake hose to the brackets.
3. Install the brake hose retainers to the hose fittings.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake pipes (1) to the brake hose.
Tighten the fittings to 21 Nm (15 ft. lbs.).
5. Bleed the hydraulic brake system.
6. Lower the vehicle.
