pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Deployment Procedures|Page 7639 > < Deployment Procedures|Page 7637
Page 10
background image

1. Turn the ignition switch to the OFF position.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove all loose objects from the front seats.
5. Disable the SIR system. Refer to SIR Disabling and Enabling Zones.

CAUTION:  A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual
stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.

6. Disconnect the inflatable restraint steering wheel module yellow connector (4) located next to steering column (2).

IMPORTANT:  If vehicle is equipped with dual stage air bags the steering wheel module and IP module will each have 4 wires and standard air bags
will only have 2 wires. Refer to SIR Connector End Views for determining high and low circuits.

7. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
8. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.

Deployment Procedures|Page 7639 > < Deployment Procedures|Page 7637