Aztek AWD V6-3.4L VIN E (2004)
Evaporator Temperature Sensor / Switch: Service and Repair
EVAPORATOR TEMPERATURE SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the evaporator core.
IMPORTANT: Carefully remove the evaporator temperature sensor using needle nose pliers.
2. Remove the evaporator temperature sensor from the evaporator core.
INSTALLATION PROCEDURE
IMPORTANT: The evaporator temperature sensor location is critical.
1. Install the evaporator temperature sensor to the evaporator core. The evaporator temperature sensor should be approximately 3.5 cm (1.4 in) from
the side and 5.0 cm (2.0 in) from the bottom corner of the evaporator core.
IMPORTANT: Align the evaporator temperature sensor wires with the opening in the upper HVAC module case. Improper alignment will pinch and
may cut the evaporator temperature sensor wires.
2. Install the evaporator core.