Aztek AWD V6-3.4L VIN E (2004)
Installation Procedure
1. Install the automatic level control height sensor link onto the height sensor arm.
2. Install the automatic level control height sensor with the bracket onto the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the automatic level control height sensor bracket bolts (1).
4. Tighten the height sensor bracket bolts to 85 Nm (63 ft. lbs.).
5. Install the automatic level control sensor link to the lower control arm ball stud.
5. Install the automatic level control sensor electrical connector (1).
6. Lower the vehicle.
7. Perform a diagnostic system check. Refer to Diagnostic System Check - Automatic Level Control (With Inflator).