Aztek AWD V6-3.4L VIN E (2004)
2. Connect the pressure hose into the retaining bracket.
3. Install the pressure hose to the steering gear.
Tighten the pressure hose filling to 27 Nm (20 ft. lbs.).
4. Install the retainer stud to the pipe rear clip, if applicable.
5. Connect the wiring harness to the rear clip stud.
6. With front wheel drive vehicles, install the pipe retainer.
7. Install the right side splash panel.
8. Lower the vehicle.
9. Notice: Refer to Fastener Notice in Service Precautions.
Install the pressure hose to the pump.
Tighten the pressure hose fitting to 27 Nm (20 ft. lbs.).
10. Install the drive belt.
11. Bleed the power steering system.