Aztek AWD V6-3.4L VIN E (2004)
Wheel Hub: Service and Repair
Front Suspension
Wheel Bearing/Hub Replacement - Front
Tools Required
^
J28733-B Front Hub Spindle Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Disconnect the wheel speed sensor electrical connector.
4. Remove the wheel speed sensor electrical connector from the bracket.
5. Remove the wheel drive shaft nut.
6. Remove the brake rotor.
7. Install the J28733-B to the wheel bearing/hub.
8. Use the J28733-B in order to push the wheel drive shaft out of the wheel bearing/hub.