Bonneville V6-3800 3.8L (1991)
FIGURE 1
FIGURE 3
SERVICE PROCEDURE:
1. Raise vehicle to access hose to pipe worm gear clamps at positions shown in Figure 1.
2. Loosen both clamps.
3. Push hoses over stop (2nd) beads approximately 5 mm (see Figure 3).
4. Slide the clamp over the stop bead and torque to 1.8 N-m
.4 N-m (16 lbs.in. +/- 3.5 lbs.in.).
5. Install a second screw gear clamp (Part Number 22527587 or equivalent) over the initial (1st) bead and torque as in step 4.
6. If equipped with auxiliary oil cooler proceed with Step 7. If not equipped with auxiliary oil cooler, lower vehicle. Check fluid level and add as
needed.
7. Remove right side headlamp module.
8. Loosen four (4) clamps (see Figure 2) and remove and discard cooler pipe to auxiliary cooler hoses.
9. Install new hoses, part number (upper) 25608924, (lower) 25608925 and torque clamps to 1.8 N-m +/- .4 N-m (16 lbs.in. +/- 3.5 lbs.in.).
10.
Reinstall right side headlamp module.
11.
Check transaxle fluid level and add as needed.
VIN BREAKPOINT Start of Production M1227785
