Bonneville V6-3800 3.8L Supercharged (1992)
Fig. 49 Rear Wheel Speed Sensor Replace
Fig. 50 Rear Wheel Speed Sensor
Rear
Refer to Figs. 49 and 50, during removal and installation procedure.
1.
Remove hub and bearing assembly.
2.
Clean area surrounding sensor housing/interface area.
3.
Remove Torx type screws securing sensor, then the sensor. Do not allow dirt or other contaminants to enter sensor housing.
4.
Do not add lubricant to bearing through sensor housing opening. This bearing is lubricated for life of vehicle.
5.
Do not clean grease from toothed sensor ring. Grease does not effect operation of sensor.
6.
Reverse procedure to install. Ensure O-ring is not torn or missing. Torque Torx screws to 33 inch lbs.