Bonneville V6-3800 3.8L Supercharged (1992)
INSTALLATION:
1.
If installing a new IAC valve, measure the distance between the tip of the pintle and the mounting flange.
^ If greater than 28 mm, use finger pressure to slowly retract the pintle. The force required to retract the pintle of a new valve will not cause
damage to the valve.
2.
Lubricate the IAC valve O-ring with clean engine oil.
3.
Install the IAC valve assembly.
4.
Install the IAC valve attaching screws, and tighten to 3.0 Nm (27 lb.in).
5.
Connect the IAC valve electrical connector.
6.
START the engine and allow it to reach operating temperature.
NOTE: No physical adjustment of the IAC valve assembly is required after installation. The IAC valve is reset by the ECM when the ignition is turned
ON, and then OFF.