Bonneville V6-3800 3.8L Supercharged (1992)
![background image](/pontiac/bonneville/v6-3800_3.8l_supercharged/Page-1553002.png)
Owner and Dealer Information
OWNER NOTIFICATION
Owners will be notified of this campaign on their vehicles by Pontiac Division (see copy of Owner Letter included with this bulletin).
DEALER CAMPAIGN RESPONSIBILITY
Dealers are to service all vehicles subject to this campaign at no charge to owners, regardless of mileage, age of vehicle, or ownership from this time
forward.
Whenever a vehicle subject to this campaign is taken into your new or used vehicle inventory, or it is in your dealership for service in the future, you
should take the steps necessary to be sure the campaign correction has been made before reselling or releasing the vehicle.
Owners of vehicles recently sold from your new vehicle inventory are to be contacted by the dealer, and arrangements made to make the required
modification according to instructions contained in this bulletin.
Parts Information
Two retaining clips for each vehicle involved will be shipped to involved dealers by Pontiac Division on a no-charge basis.
DO NOT ORDER PARTS FOR THIS CAMPAIGN FROM GENERAL MOTORS SERVICE PARTS OPERATION (GMSPO).
If additional retaining clips, shift levers or shift control cable brackets are required, they can be obtained from Pontiac Division in Pontiac, MI by calling
313-857-6038 during normal working hours. Parts will be shipped overnight express on a no charge basis. Order additional parts, if required, from
Pontiac Division using the following information:
Part
Quantity
Description
Number
Per Vehicle
Retaining Clip
NPN
2
Shift Lever
25551336
As Required
Shift Control Cable Bracket
25527503
As Required
NOTICE:
Less than 5% of the vehicles will require a shift lever or shift control cable bracket. These parts are not to be ordered unless inspection
indicates that part replacement is required.
Service Procedure
1.
Set parking brake and open hood.
2.
Inspect shift control cable bracket mounted below cruise servo unit. Bracket color should be gray. If bracket color is black, it must be replaced
with part number 25527503. See parts information section to obtain new shift control cable bracket. Nut torque for shift control cable bracket to
transaxle is 24 N-m (18 lb.ft.).
FIGURE 2