Bonneville V8-4.6L VIN Y (2004)
Front Door Weatherstrip: Service and Repair
Front Side Door Upper Auxiliary Weatherstrip Replacement
Front Side Door Upper Auxiliary Weatherstrip Replacement
Removal Procedure
1. Remove the upper door trim panel.
2. Remove the outside rearview mirror.
3. Partially remove the window weatherstrip to access the upper auxiliary molding screws.
4. Remove the auxiliary window weatherstrip screws (1-7).
5. Carefully peel the auxiliary window weatherstrip away from the door header.
Installation Procedure
1. Align the rear hole (1) in the weatherstrip to the plastic nut in the door header.
2. Seat the top of the seal lip over the flange.
3. Starting at the rear, roll the weatherstrip over the flange on the door header while holding the weatherstrip lip to prevent tucking under against the
door.
4. Install the rear screw (1).
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the remaining screws.
Tighten the screws, (1) first, then (2-7) to 2 N.m (18 lb in).
6. Install the window weatherstrip.
7. Install the outside rearview mirror.
8. Install the upper door trim panel.