Bonneville V8-4.6L VIN Y (2004)
1. Install new sealing washers to the discharge hose.
2. Install the discharge hose (3) to the compressor.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the discharge hose nut (2) to the compressor.
Tighten
Tighten the nut to 16 N.m (12 lb ft).
4. Connect the electrical connector to the A/C refrigerant pressure sensor (1).
5. Lower the vehicle.
6. Install the discharge hose to the condenser.
7. Install the discharge hose nut to the condenser.
Tighten
Tighten the nut to 20 N.m (15 lb ft).
8. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
9. Leak test the fittings of the component using the J 39400-A.