Bonneville V8-4.6L VIN Y (2004)
Control Module HVAC: Service and Repair
HVAC System - Automatic
Blower Motor Control Processor Replacement
BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right sound insulator.
2. Remove the instrument panel compartment.
3. Remove the Dash Integration Module (DIM) from the bracket and position aside.
4. Remove the rear DIM bracket screws and lower the bracket enough to access the blower module.
5. Disconnect the electrical connector (1).
6. Remove the blower control module retaining screw.
7. Remove the blower control module.
INSTALLATION PROCEDURE
1. Install the blower control module.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the retaining screw.
Tighten
Tighten the screw to 2 N.m (18 lb in).
3. Connect the electrical connector (1).
4. Install the DIM bracket screws.
Tighten
