Bonneville V8-4.6L VIN Y (2004)
Negative: Service and Repair
Replacement procedure
BATTERY NEGATIVE CABLE REPLACEMENT
REMOVAL PROCEDURE
IMPORTANT:
-
Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
-
Always route the replacement cable the same way as the original cable.
1. Disconnect the battery negative cable.
2. Disconnect the body harness from the battery negative cable.
3. Disconnect the battery negative cable from the floor pan.
4. Remove the battery negative cable from the vehicle.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: When installing the battery negative cable, be sure that the cable eyelet is installed with the flat side down. Keep the crimped side
facing upward.
1. Connect the body end of the battery negative cable to the floor pan.
Tighten
Tighten the battery negative cable to floor pan bolt to 36 N.m (27 lb ft).