Workshop Manuals Factory service & repair Pontiac

Pontiac common faults and how to fix them

Faults that are well known on Pontiac models we hold manuals for: what the owner notices, what causes it, and the pages in our manuals that cover the repair.

Pontiac Aztek stalling: ignition relay recall (2004)

Symptoms

The engine stalls without warning while driving, and it can't be restarted straight away. It may happen only occasionally.

Cause

NHTSA recall 05V157000 (GM recall 05014) covers certain Pontiac Aztek and Buick Rendezvous SUVs. Contamination on the ignition relay contacts causes high resistance, which affects the signals to the powertrain control module and can make the engine stall at any time.

Fix

Check with a GM dealer that the recall has been done; the remedy replaces the ignition relay free of charge. On an Aztek with intermittent stalling, the Pontiac Aztek ignition relay is the first thing to check, along with any stored codes in the engine computer. If the relay has already been replaced and stalling continues, check the ignition switch and the wiring to the computer.

Repair instructions on this site

Sources: NHTSA recall 05V157000 (GM recall 05014).

Pontiac Aztek wheel bearing: hum or growl from the front and ABS light (2002–2004)

Symptoms

A hum, growl or groan from the front wheels at speeds above about 10 mph. The ABS warning lamp on the instrument panel may also come on.

Cause

GM special policy 06036A covers 2002–2004 Pontiac Aztek and Buick Rendezvous models. It found premature wear of the front wheel bearings, and extended coverage for their replacement to 5 years or 60,000 miles from first registration. That coverage has long expired, but the bulletin confirms the fault.

Fix

Raise the front and check each wheel for play and rough rotation, and read any ABS codes. A worn front wheel bearing is replaced; the Pontiac Aztek wheel bearing bulletin covers the parts. Torque the hub nut to the figure in the manual, and clear the ABS codes afterwards. If one side has worn, check the other.

Repair instructions on this site

Sources: GM special policy adjustment 06036A (January 2007).

Pontiac P0171: lean code and misfire on the G5 and G6 2.4 (2006–2007)

Symptoms

The check engine light comes on with P0171 (system too lean), P0300 (random misfire) or P1174. The car usually drives normally, though some idle roughly.

Cause

GM bulletin 08-06-04-001B covers the 2007 Pontiac G5 and G6 and the 2006 Pursuit (Canada), and the Chevrolet Cobalt and HHR and Saturn ION, with the 2.4 engine (LE5). The small director plate orifices on one or more fuel injectors clog up, so the engine runs lean on that cylinder.

Fix

Smoke-test for vacuum leaks and check the mass airflow sensor first. Then run an injector balance test, as the Pontiac P0171 bulletin describes. The bulletin warns that cleaning will not clear the director plates, so any injector that fails the test is replaced. Clear the codes and recheck the fuel trims afterwards.

Repair instructions on this site

Sources: GM service bulletin 08-06-04-001B.

Pontiac Firebird knock sensor: P0332 and spark knock on the LS1 (1998–2002)

Symptoms

A mild to severe pinging (spark knock), usually worse under acceleration, and the check engine light on with P0332 (knock sensor 2 circuit).

Cause

GM bulletin 02-06-04-023A covers the 1998–2002 Pontiac Firebird and Chevrolet Camaro and Corvette with the 5.7 LS1, and GM trucks of the same years. Water gets into the cavity under the intake manifold where the rear knock sensor sits, and corrodes the sensor. It is more common where the engine bay is often washed.

Fix

The knock sensors sit under the intake manifold, so the manifold has to come off. The Firebird knock sensor bulletin replaces the rear sensor and builds a dam of RTV sealant around it to keep water away. Check the wiring to both sensors while the manifold is off, and fit new intake gaskets when it goes back.

Repair instructions on this site

Sources: GM service bulletin 02-06-04-023A.