Fiero L4-151 2.5L (1985)
Sunroof / Moonroof Weatherstrip: Customer Interest
Sunroof (Vista Vent) - Water Leaks
Number
86-10-1
Date
1/86
Subject:
VISTA VENT WATER LEAKS
1984-86 FIERO (WITH AD3)
Conditions, which contribute to water leaks on 1984 to 1986 Fiero vista vents, can be repaired by adding drainage holes to the plastic roof outer panel
and replacement of hardware nuts at the hinge and latch locations on the glass panel..
This bulletin contains procedures for the addition of holes to the plastic roof outer panel, description and part numbers of new hardware nuts as well as
proper sealing patterns for weatherstrips (if weatherstrip replacement is necessary).
The addition of holes provides a water drain system and are to be drilled through the Plastic Roof Outer Panel Only. The holes are to be located in all
four (4) corners of the weatherstrip mounting area. Figure 1 shows the location of the holes with the weatherstrip removed for illustrative purposes.
The recommended procedure for adding holes to the roof outer panel is as follows:
1.
Remove the vista vent glass assembly from the vehicle and place on a clean work surface.
FIGURE 1 - PLASTIC ROOF OUTLET PANEL
2.
During the following drilling operations, it will be necessary to hold the weatherstrip out of the way to prevent damage. Using an electric drill
motor and 3/16" drill bit, drill one hole (through the plastic roof outer panel only) in each corner of the weatherstrip cavity as shown in Figure 1,
view A.
3.
Reinstall the vista vent glass assembly to the vehicle and water test to insure an acceptable repair.
4.
After water testing, remove the vista vent glass assembly and dry the roof inner panel by blowing compressed air through the holes in the roof
outer panel. Apply a small amount of GM P/N 1052856 anti-corrosion compound (or equivalent) through the holes in the roof outer panel to
protect the metal roof inner panel from corrosion caused by damage done during drilling operations.